Well all the parts FINALLY arrived and the insert goes in tomorrow However, when the shop was loading it into my truck I noticed that the clean out block off plate appears to be nothing more than the oval blank that was cut out of the exhaust opening. Not only that, but on closer inspection, it looks like it just sets on a thin rail slightly below the clean out opening and just lays over the clean out opening to redirect the gasses towards the front of the insert. Is this right or is the actual clean out insert MIA?
<removed dead image link>
Harman Insert Clean Out Block Off Plate
- jeromemsn
- Member
- Posts: 1088
- Joined: Thu. Oct. 04, 2007 12:30 am
- Location: Edwardsburg, Mi. 49112
- Hot Air Coal Stoker Furnace: Keystoker 90 dvc
- Hand Fed Coal Stove: Harman elite fireplace insert
Yes, thats the plate, and thats the way it sits. Take a couple of good pictures during and at the end of the installation if you can. Your pictures are extremely good ones.