Score!!

 
User avatar
mntbugy
Member
Posts: 1355
Joined: Fri. Dec. 23, 2016 2:36 pm
Location: clearfield,pa
Hand Fed Coal Stove: D S 1500, Warm Moring 400
Baseburners & Antiques: Art Garland 145,GW114 ,Clarion 115, Vestal 20 Globe,New Royal22 Globe, Red Cross Oak 56,Acme Ventiduct 38,Radiant Airblast 626,Home Airblast 62,Moores #7,Moores 3way
Coal Size/Type: stove and nut and some bit
Other Heating: Propain

Post by mntbugy » Sun. Jan. 10, 2021 9:48 pm

Flower shaped nuts are called Rosetts. They most likely went on mica doors on the outside. They are 5 dollars each, if you can find someone who has extras.

Real nice find. :clap:


 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Sun. Jan. 10, 2021 10:05 pm

Well I practically blew my left Rosett out getting this thing through my doorway this evening. Lol

 
User avatar
McGiever
Member
Posts: 9258
Joined: Sun. May. 02, 2010 11:26 pm
Location: Junction of PA-OH-WV
Stoker Coal Boiler: AXEMAN-ANDERSON 130 "1959"
Hand Fed Coal Boiler: BUCKET A DAY water heater
Hand Fed Coal Stove: Warm Morning 414A
Coal Size/Type: RICE,PEA,NUT,STOVE /ANTHRACITE and EGG / BIT
Other Heating: Ground Source Heat Pump and some Solar

Post by McGiever » Wed. Jan. 13, 2021 1:03 am

fig wrote:
Sun. Jan. 10, 2021 12:43 pm
Thanks for the clean up tips. That’s just what I needed to know. Yes the top swings. Some of the mica has cracks but it doesn’t look like it’s anything that is completely open. I’ll need to get some anyway. I’m not sure it will clean up enough to see through. I’ve got a few pieces I’ve stashed away somewhere, just have to dig it out. It’s not enough to replace them all but maybe some of the ones with bad cracks.

I better start researching lining the pot. It looks pretty good. Want to keep it that way.
Not any expert but "suspended firepots" do not get lined...being as it is suspended, air is always moving on all sides. Some stove owners might have a spare pot re-cast, but do compensate for shirinkage in the new cast.
Sure someone will chime in if I mis-spoke. ;)

 
User avatar
mntbugy
Member
Posts: 1355
Joined: Fri. Dec. 23, 2016 2:36 pm
Location: clearfield,pa
Hand Fed Coal Stove: D S 1500, Warm Moring 400
Baseburners & Antiques: Art Garland 145,GW114 ,Clarion 115, Vestal 20 Globe,New Royal22 Globe, Red Cross Oak 56,Acme Ventiduct 38,Radiant Airblast 626,Home Airblast 62,Moores #7,Moores 3way
Coal Size/Type: stove and nut and some bit
Other Heating: Propain

Post by mntbugy » Wed. Jan. 13, 2021 1:33 pm

Mac, back in the day, grates and firepots were disposable items. Something broke or cracked, just order a new one.

Firepots "should" have some kind of liner. If you want them to last another 100 years.

 
User avatar
Seagrave1963
Member
Posts: 180
Joined: Fri. Sep. 26, 2014 7:12 pm
Location: Eastern Shore of Maryland
Hand Fed Coal Stove: Harman TLC2000
Coal Size/Type: nut
Other Heating: electric heat pumps, propane fireplace

Post by Seagrave1963 » Wed. Jan. 13, 2021 2:01 pm

fig - that is one beautiful coal stove! Nice score!

 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Wed. Jan. 13, 2021 2:06 pm

I was thinking 1/2” thick liner and not covering the half radius slots in the bottom. It’s 16” and that will knock it down to 15”. I really don’t want to go any smaller.


I wonder what it costs to get a spare one cast? Who does that?

Thanks Seagrave! Yeh I’ve had a very lucky year. Now if only the lottery tickets would pay off.

 
User avatar
mntbugy
Member
Posts: 1355
Joined: Fri. Dec. 23, 2016 2:36 pm
Location: clearfield,pa
Hand Fed Coal Stove: D S 1500, Warm Moring 400
Baseburners & Antiques: Art Garland 145,GW114 ,Clarion 115, Vestal 20 Globe,New Royal22 Globe, Red Cross Oak 56,Acme Ventiduct 38,Radiant Airblast 626,Home Airblast 62,Moores #7,Moores 3way
Coal Size/Type: stove and nut and some bit
Other Heating: Propain

Post by mntbugy » Wed. Jan. 13, 2021 2:40 pm

fig wrote:
Wed. Jan. 13, 2021 2:06 pm

I wonder what it costs to get a spare one cast? Who does that?


About 300 with shipping and handling.
Tomahawk foundry.


 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Wed. Jan. 13, 2021 6:21 pm

Hmm wasn’t far from them when I picked up the stove. Shucks.

 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Thu. Jan. 14, 2021 12:30 pm

The top lid is kind of cumbersome. It only has one hinge pin cast into and a thumb latch to try to pivot it. I’ll have to rest my hand on the top of the stove to get enough leverage to pivot that lid up. It will also slide out of its hinge while doing this if not careful. I can see that being a pain when it’s hot. It also has an odd shape to it. Strange stove but I like it.

I also found a crack in a small apron that must have occurred during the journey home. I came down 43 and that road is probably the worst road in the US. I cringed the whole way. I’m surprised that this is the only damage that happened.

Attachments

image.jpg
.JPG | 823KB | image.jpg

 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Sat. Jan. 16, 2021 5:35 pm

I was wondering if anyone could shed some light on how the flappers in the split pipe work?

Attachments

D2FF0267-5F72-4DA5-A9FE-7D45853B34E2.jpeg
.JPEG | 1.1MB | D2FF0267-5F72-4DA5-A9FE-7D45853B34E2.jpeg
B19D818E-B43F-49E5-9C83-FAC78AB5A2F7.jpeg
.JPEG | 1.1MB | B19D818E-B43F-49E5-9C83-FAC78AB5A2F7.jpeg
E39742FF-3B3F-4E98-BC26-AB04500FF58F.jpeg
.JPEG | 1.1MB | E39742FF-3B3F-4E98-BC26-AB04500FF58F.jpeg

 
User avatar
mntbugy
Member
Posts: 1355
Joined: Fri. Dec. 23, 2016 2:36 pm
Location: clearfield,pa
Hand Fed Coal Stove: D S 1500, Warm Moring 400
Baseburners & Antiques: Art Garland 145,GW114 ,Clarion 115, Vestal 20 Globe,New Royal22 Globe, Red Cross Oak 56,Acme Ventiduct 38,Radiant Airblast 626,Home Airblast 62,Moores #7,Moores 3way
Coal Size/Type: stove and nut and some bit
Other Heating: Propain

Post by mntbugy » Sat. Jan. 16, 2021 6:19 pm

Can't see much in your pics.

Lift out the magazine to see in front of stove thru load door. Then play with levers.

Lever one way sends gases up and out to chimney. The other way sends gases down the back pipe, then under ash pan, then up the opposite side of back pipe to up and out chimney.

What writing is on that lever. Between sheetmetal jacket and back pipe??

 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Sat. Jan. 16, 2021 6:44 pm

Oh good eye. I didn’t even notice that. I’ll have to investigate that when I get home later. Had to work tonight.

 
Straick
New Member
Posts: 7
Joined: Tue. Jan. 12, 2021 11:15 am

Post by Straick » Sat. Jan. 16, 2021 7:12 pm

Fig, I see something real nice hiding under that dust there. Can't wait to see it all cleaned up.
Is that damper/flapper system that you have something that is common on coal stoves? It seems like it would have clogging issues with flyash.

 
fig
Member
Posts: 711
Joined: Fri. Feb. 12, 2016 2:36 pm
Hand Fed Coal Stove: Round Oak 1917 Door model O-3, Florence No.77, Warm Morning 523-b
Hand Fed Coal Furnace: Hotblast 1357
Coal Size/Type: Bituminous stove coal
Other Heating: woodstock fireview, enviro omega

Post by fig » Sat. Jan. 16, 2021 7:19 pm

It’s what is known as a base burner. The flaps enable the flue gases to be redirected under the burn pot to extract more heat. I think some might even be able to re-burn flue gases but I’m not sure. I’m not really all that familiar with them.

 
User avatar
Vonda
Member
Posts: 209
Joined: Fri. Dec. 09, 2016 1:20 am
Location: Atlanta
Hand Fed Coal Stove: Chubby born 1980
Coal Size/Type: Nut
Other Heating: Gas

Post by Vonda » Sat. Jan. 16, 2021 9:05 pm

Well, I am a little jealous.


Post Reply

Return to “Hand Fired Coal Stoves & Furnaces Using Anthracite”