I-Box Setup

Post Reply
 
User avatar
wilder11354
Member
Posts: 1221
Joined: Sat. Jan. 29, 2011 10:48 pm
Location: Montrose, Pa.
Hand Fed Coal Boiler: Harman SF260 Boiler
Hand Fed Coal Stove: Hitzer 50-93
Coal Size/Type: nut or pea, anthracite
Other Heating: crown oil boiler, backup.if needed

Post by wilder11354 » Sun. Jan. 29, 2017 3:37 pm

did a rough setup of Incra I-box finger joint cutter. Set it up as a right hand tilt blade on tablesaw. If I am correct, blade tilts to right from operating position its right tilt. Anybody out here know if it right or wrong, please let me know.
Ibox1.jpg
.JPG | 99.4KB | Ibox1.jpg
Ibox2.jpg
.JPG | 82.4KB | Ibox2.jpg
Ibox3.jpg
.JPG | 101.8KB | Ibox3.jpg
Ibox4.jpg
.JPG | 106.9KB | Ibox4.jpg

 
cabinover
Member
Posts: 2344
Joined: Wed. Feb. 04, 2009 7:13 am
Location: Fair Haven, VT
Stoker Coal Boiler: Hybrid Axeman Anderson 130
Baseburners & Antiques: Sparkle #12
Coal Size/Type: Pea, Buckwheat, Nut
Other Heating: LP Hot air. WA TX for coal use.

Post by cabinover » Sun. Jan. 29, 2017 3:50 pm

Wish I could help you but I have never seen or heard of the product. Do have an Incra miter fence though, works much better than the stock POS.


 
waldo lemieux
Member
Posts: 2270
Joined: Sun. Sep. 30, 2012 8:20 pm
Location: Ithaca,NY

Post by waldo lemieux » Mon. Jan. 30, 2017 8:58 am

Wildman, I understand your question to be, if the blade tilts to the right as your standing behind the saw, is it a right tilt saw.? if thats the question, then the answer is yes. Most all contractor saws are right tilt. Some higher end cabinet saws are left tilt. I have one and it would be nice if I had a right as well, sometimes its nice to have a choice.

 
User avatar
wilder11354
Member
Posts: 1221
Joined: Sat. Jan. 29, 2011 10:48 pm
Location: Montrose, Pa.
Hand Fed Coal Boiler: Harman SF260 Boiler
Hand Fed Coal Stove: Hitzer 50-93
Coal Size/Type: nut or pea, anthracite
Other Heating: crown oil boiler, backup.if needed

Post by wilder11354 » Mon. Jan. 30, 2017 6:15 pm

waldo lemieux wrote:Wildman, I understand your question to be, if the blade tilts to the right as your standing behind the saw, is it a right tilt saw.? if thats the question, then the answer is yes. Most all contractor saws are right tilt. Some higher end cabinet saws are left tilt. I have one and it would be nice if I had a right as well, sometimes its nice to have a choice.
Thank You Waldo!! so good on incra box set up, just need scrap wood, and dado blade installed to practice using it.

Post Reply

Return to “House, Gardening & DIY Projects”