Shop Exhaust/Vent Fan

 
User avatar
windyhill4.2
Member
Posts: 6072
Joined: Fri. Nov. 22, 2013 2:17 pm
Location: Jonestown,Pa.17038
Stoker Coal Boiler: 1960 EFM520 installed in truck box
Hand Fed Coal Stove: Crane 404 with variable blower
Coal Size/Type: 404-nut, 520 rice ,anthracite for both

Post by windyhill4.2 » Sat. Dec. 10, 2016 9:58 am

top top wrote:Just saw your post, have you looked at an actual duct fan? These are available in various sizes from about 4" on up and do exactly as you described. A fan mounted on the wall, a flexible hose on each side. My coal stove is in a room with high ceilings, the adjacent rooms are much lower so the heat doesn't circulate very well. I use two of these with the intake hose connected to a trim ring near the ceiling in that room, the discharge side to a trim ring near the floor in the adjacent rooms.

http://www.homedepot.com/p/Suncourt-Inductor-4-in-Corded-In- ... pkw__pmt_e_
That sounds like a good idea for a project I am considering in my house.
I will consider that as a possibility for my shop project too.


Post Reply

Return to “House, Gardening & DIY Projects”