In you pics it looks like you have a wood floor. The stove cannot sit on a combustible surface.
New to coal
-
- Member
- Posts: 3966
- Joined: Fri. Aug. 16, 2019 3:02 pm
- Location: Oneida, N.Y.
- Hand Fed Coal Stove: Harmon Mark II
- Hand Fed Coal Furnace: Looking
- Baseburners & Antiques: Looking
- Coal Size/Type: Nut
- Other Heating: newmac wood/coal combo furnace
-
- Member
- Posts: 2379
- Joined: Sun. Mar. 25, 2007 8:41 pm
- Location: Ithaca, New York
- Stoker Coal Boiler: Keystoker KAA-4-1 dual fuel boiler
- Hand Fed Coal Boiler: former switzer CWW100-sold
- Coal Size/Type: rice
- Other Heating: kerosene for dual fuel Keystoker/unused
Bon Jour Mon Ami.
If the stainless is thick enough that should be fine.
The stove flue breech is male and the stove pipe attached to the breech is a tight female connection.
If the pipe is not tight you need stove gasket rope to seal the joint and to also use the Permatex high temperature
gasket sealant over the joint in a thick bead using a disposable latex glove to spread it.
Be sure to pick up a tube of Permatex red high temperature gasket sealer to help seal the stove pipe joints.
If the stainless is thick enough that should be fine.
The stove flue breech is male and the stove pipe attached to the breech is a tight female connection.
If the pipe is not tight you need stove gasket rope to seal the joint and to also use the Permatex high temperature
gasket sealant over the joint in a thick bead using a disposable latex glove to spread it.
Be sure to pick up a tube of Permatex red high temperature gasket sealer to help seal the stove pipe joints.